[SOLVED] stuck at emmc

[dr_dre]

is there any way to write spi to factory settings again ( using uart or so) this is the output from serial
------------

U-Boot SPL 2017.09-ga0a2b48 (Mar 29 2018 - 21:57:02)
setup_ddr_param 1
booted from SPI flash
Trying to boot from SPI
"Synchronous Abort" handler, esr 0x02000000
ELR: 10000
LR: 1890
x 0: 0000000000400000 x 1: 0000000000000000
x 2: 0000000000010000 x 3: 0000000000000180
x 4: 0000000000000009 x 5: 0000000000000073
x 6: 00000000001fff86 x 7: 0000000000000003
x 8: 0000000000000340 x 9: 0000000013d92d40
x10: 00000000005ffc0c x11: 00000000001ffb80
x12: 000000000000030d x13: 0000000000000300
x14: 00000000005ffc5c x15: 00000000001ffb80
x16: 0000000000000000 x17: 0000000000000000
x18: 00000000005ffea0 x19: 000000000000d498
x20: 000000000000d480 x21: 0000000000000000
x22: 00000000005ffe70 x23: 00000000005ffe58
x24: 000000000000b50b x25: 000000000000b4f3
x26: 000000000000d000 x27: 00000000deadbeef
x28: 0000000000000430 x29: 00000000005ffde0

Resetting CPU ...

DDR version 1.08 20170628
In
SRX
LPDDR3
333MHz
Bus Width=32 Col=11 Bank=8 Row=15/15 CS=2 Die Bus-Width=32 Size=4096MB
ddrconfig:7
OUT

U-Boot SPL 2017.09-ga0a2b48 (Mar 29 2018 - 21:57:02)
setup_ddr_param 1
booted from SPI flash
Trying to boot from SPI

----------