10-03-2016, 05:15 PM
(10-02-2016, 04:01 AM)pfeerick Wrote:(10-01-2016, 11:58 PM)dkryder Wrote: seems like you are not the only one.
https://github.com/resin-io/etcher/issues/573
they tried closing a few times in july, then did close 8/02, so it seems they did that too early unless you are using an older version
Looks like they may have introduced a better one, unless my case was an oddball one due to upgrading... I had validation errors at about 13%... so I took my business elsewhere (Rufus) and didn't regret it! I suppose if it is going to have a dummy spit, at least it didn't leave me hanging for the 99% failure! :-D
@Topgun505 Don't worry mate... you'll be doing a lot of learning... these SBC (single-board computers) are an quite a different beast to your average x86/PowerPC/AMD computer!!!Keep on asking questions, and we'll do our best to lead you astray.... er, help you out!
Ok. Tried win32imager and it completed the write ok. Tried to boot up again. Same deal. Nothing.
