05-23-2021, 02:15 PM
Hello,
I'm not sure if this is the right place to inquire about my issue about this product fault, but recently I've purchased along the PinePhone the aforementioned Powersupply which seems to show some lack of QC.
So I gently opened the Powersupply up out of curiosity to check the internals and making sure the Solder Joints were good, I noticed something blown/broken near the capacitors of the Unit (and bit of rust on one pin and excess glue on the Mainboard) .
I can't identify what the F1 label meant in regards to the component which looks like a fuse (cfr. pic below), so I wanted to know If someone could tell me where I could get a replacement for that part or schematics for this unit?
Also the unit is itself still working, but I don't know if it's something expected to have when buyng a new unit.
Thanks in advance
imgur.com/a/VImNdFQ
![[Image: VImNdFQ]](https://imgur.com/a/VImNdFQ)
I'm not sure if this is the right place to inquire about my issue about this product fault, but recently I've purchased along the PinePhone the aforementioned Powersupply which seems to show some lack of QC.
So I gently opened the Powersupply up out of curiosity to check the internals and making sure the Solder Joints were good, I noticed something blown/broken near the capacitors of the Unit (and bit of rust on one pin and excess glue on the Mainboard) .
I can't identify what the F1 label meant in regards to the component which looks like a fuse (cfr. pic below), so I wanted to know If someone could tell me where I could get a replacement for that part or schematics for this unit?
Also the unit is itself still working, but I don't know if it's something expected to have when buyng a new unit.
Thanks in advance
imgur.com/a/VImNdFQ
