Dreaded Tight Hinge
Unfortunately, my Pinebook Pro has suffered from the failure of the mount that fastens the hing to the base.    I believe it may be because of tightening of the hinge on the USB-C side of the machine.

I know I need to order  a new top shell to repair the machine.   However, I'm worried that if the hinge is too tight, that the same failure will occur again prematurely. 

Should I consider trying to replace the hinges on the display too?   I'm not even sure that the hinges can be  obtained without purchasing a whole display ( which is probably impossible to get at the moment ).

Any advice or experience anyone has with repairing this problem would be appreciated.


Messages In This Thread
Dreaded Tight Hinge - by karlyn - 10-29-2020, 10:10 PM
RE: Dreaded Tight Hinge - by vfr400racer - 10-30-2020, 05:00 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Pinebook Pro Broken Hinge uncmonky 1 1,358 08-02-2020, 01:43 PM
Last Post: Arwen

Forum Jump:

Users browsing this thread: 1 Guest(s)