How to connect with wifi ?

[yirmidokuz]

Hi all,

I got my pine64 + 2gb model.

I boot the pine64 with Debian Linux with Mate GUI 20160422 by lenny.raposo with Longsleep kernel.

I have no experience with any of the Linux OS'.

How can I activate the wifi, and connect the internet ?

[baryluk]

I did not try to connect, but on my mate installation I do have an icon on the right top side of a desktop (near the clock), that shows the network icon. If you click it you should see wifi card and wifi network. Just click one of them and enter the password.

[lenny.raposo-pine64.pro]

open up a terminal window and type in the following

sudo iwconfig

then post the results here

[yirmidokuz]

well, I managed to connect to internet. But now, I cannot open any webpage. It looks like, it is loading but at the and it is failed to open.

[Bio]

I too had this issue and bringing down the ethernet interface fixed it as the ethernet, though disconnected, was getting some 192.168.2.0/24 IP address for reasons I cannot understand (no DHCP server is running on the device in this image).

Code:

ifdown eth0

If you are using exclusively wifi edit the network config and comment out the auto eth0 line to stop this happening in the future;

Code:

# The primary network interface #auto eth0 iface eth0 inet dhcp

[yirmidokuz]

Where do I have to write this code ? To shell ?

uh, oh .. okay I solved it thanks ..

[Webtest]

Lenny ... You're one of the GREAT wizards in Pinedom!!!

Played with a Pine for a couple of weeks - no networking.  Now I just got my own Pine and am trying to get WiFi working but I can't find the device.

Using your:  pine64-image-debianmate-31065bsp.img.xz - it boots up fine and works!
I'm plugged into ETH0 and am writing this NOW on the Pine on the internet.

WiFi module is installed properly.  Per your 4/27 post, here is the "iwconfig":

$ sudo iwconfig
eth0      no wireless extensions.
sit0      no wireless extensions.
lo        no wireless extensions.
$

My most sincere thanks for any and all comments, suggestions, and assistance.

Blessings in abundance, all the best, & ENJOY!
Art in Carlisle, PA USA

[Webtest]

Esteemed Forum Participants and Lurkers:
==================================

EDIT:  I have to make sure I disconnect the Ethernet cable when testing the WiFi ... DUH


I've made some progress in the last few hours ... I discovered I wasn't at the latest release, so I downloaded and burned it:

    debian/debian-mate-jessie-20160501-lenny.raposo-longsleep-pine64-8GB.zip

It looks ok so far, and now I have wlan devices - yes, TWO of them - wlan0 and wlan1:

Code:

# iwconfig eth0      no wireless extensions. wlan0     IEEE 802.11bgn  ESSID:off/any            Mode:Managed  Access Point: Not-Associated   Tx-Power=12 dBm            Retry  long limit:7   RTS thr:off   Fragment thr:off          Encryption key:off          Power Management:on           sit0      no wireless extensions. lo        no wireless extensions. wlan1     IEEE 802.11bgn  ESSID:off/any            Mode:Managed  Access Point: Not-Associated   Tx-Power=12 dBm            Retry  long limit:7   RTS thr:off   Fragment thr:off          Encryption key:off          Power Management:on # ifconfig eth0      Link encap:Ethernet  HWaddr 7a:6e:63:ac:21:f1            inet addr:192.168.1.104  Bcast:192.168.1.255  Mask:255.255.255.0          inet6 addr: fe80::786e:63ff:feac:21f1/64 Scope:Link          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1          RX packets:83 errors:0 dropped:0 overruns:0 frame:0          TX packets:104 errors:0 dropped:0 overruns:0 carrier:0          collisions:0 txqueuelen:1000          RX bytes:9542 (9.3 KiB)  TX bytes:14007 (13.6 KiB)          Interrupt:114 lo        Link encap:Local Loopback            inet addr:127.0.0.1  Mask:255.0.0.0          inet6 addr: ::1/128 Scope:Host          UP LOOPBACK RUNNING  MTU:65536  Metric:1          RX packets:4 errors:0 dropped:0 overruns:0 frame:0          TX packets:4 errors:0 dropped:0 overruns:0 carrier:0          collisions:0 txqueuelen:0          RX bytes:240 (240.0 B)  TX bytes:240 (240.0 B) wlan0     Link encap:Ethernet  HWaddr 34:c3:d2:7b:45:0c            UP BROADCAST MULTICAST  MTU:1500  Metric:1          RX packets:0 errors:0 dropped:0 overruns:0 frame:0          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0          collisions:0 txqueuelen:1000          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B) wlan1     Link encap:Ethernet  HWaddr 36:c3:d2:7b:45:0c            UP BROADCAST MULTICAST  MTU:1500  Metric:1          RX packets:0 errors:0 dropped:0 overruns:0 frame:0          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0          collisions:0 txqueuelen:1000          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)

I certainly did NOT expect TWO of them, so now I'm at a loss as to where to go from here.  The MAC address for the 'real' device has to be entered into my router Access List, and I have to connect to my wireless network.

EDIT:  When I click on the network icon (top right of screen) I see the available networks, but I don't get a connection???

Thank you for any and all comments, suggestions, and assistance.


Blessings in abundance, all the best, & ENJOY!
Art in Carlisle, PA USA

[Webtest]

OK ... the final key to the solution for connecting to the Internet with the WiFi link was disconnecting the ethernet cable and issuing:

    sudo ifdown eth0

I'm not sure what I have to do when I boot up the next time, but at least I know it works if I'm persistent enough.  I definitely want to be able to use either the wired OR the WiFi Internet connection.

Blessings in abundance, all the best, & ENJOY!
Art in Carlisle, PA USA

BOAT:  A hole in water that you pour MONEY into.
LINUX:  A hole in your LIFE that you pour TIME into.

[lenny.raposo-pine64.pro]

Ladies and gentlemen a new release comes out today that will address all the issues

---

And it includes kodi on the DE systems