No audio on calls after updating today

[BaronAlbatross]

If you have the time, could you spell out your process please? I have an important call tomorrow and I have no time at all to get it wrong and make a bigger mess!

If you're talking about going back to pulseaudio after having moved to pipewire, it was basically a matter of reversing what was done - disable pipewire and re-enable pulseaudio. I had to play around with it a bit but it came down to the following commands run as the normal mobian user:

Code:

# Disable pipewire
systemctl --user stop pipewire pipewire.socket pipewire-pulse
systemctl --user disable pipewire pipewire.socket pipewire-pulse
systemctl --user mask pipewire pipewire.socket pipewire-pulse

# Enable pulseaudio
systemctl --user unmask pulseaudio pulseaudio.socket
systemctl --user enable pulseaudio pulseaudio.socket
systemctl --user start pulseaudio pulseaudio.socket

It's a good idea to keep a "known to work" SD card on hand just in case. Don't update it once it's you have it in a workable state. Having that has saved my bacon on a few occasions.

Thank you so much! I think I will make a backup after this, it should have been common sense!