PINE64   ›   Pinebook Pro   ›   Linux on Pinebook Pro   ›   Using UART

Thread Closed 
Using UART
VoxUnius
Pine Adept
***
Joined: Jul 2019
Posts: 30

Reputation: 2
#1
11-19-2019, 07:39 AM
Hi Everyone,

Just wonder if there's any guide on how to read the console via UART?

I've done everything written in the wiki:

1. Bought the USB to DB9 cable.
2. Soldered a 3.5mm audio jack to it (pin 2 - to the tip, pin 3 - to the ring, pin 5 - to the sleeve).
3. Switched the UART toogle on.
4. Plugged everything in.
5. Ran screen /dev/ttyUSB0 1500000.
6. Powered on the PBP.
7. Saw nothing.

Am I missing anything here?
Thread Closed 


Messages In This Thread
Using UART - by VoxUnius - 11-19-2019, 07:39 AM
RE: Using UART - by neilman - 11-19-2019, 08:15 AM
RE: Using UART - by VoxUnius - 11-19-2019, 08:35 AM
RE: Using UART - by neilman - 11-19-2019, 10:12 AM
RE: Using UART - by xalius - 11-19-2019, 03:27 PM
RE: Using UART - by VoxUnius - 11-19-2019, 04:02 PM
RE: Using UART - by pfeerick - 11-19-2019, 05:03 PM
RE: Using UART - by VoxUnius - 11-19-2019, 05:57 PM
RE: Using UART - by pfeerick - 11-19-2019, 09:08 PM
RE: Using UART - by VoxUnius - 11-20-2019, 12:02 AM
RE: Using UART - by pfeerick - 11-20-2019, 02:40 AM
RE: Using UART - by VoxUnius - 11-21-2019, 10:58 PM
RE: Using UART - by pfeerick - 11-22-2019, 03:38 AM
RE: Using UART - by Arwen - 11-22-2019, 05:01 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Repurpose debug UART as GPIO wishindo 3 983 04-13-2023, 07:10 AM
Last Post: KC9UDX

Forum Jump:


Users browsing this thread: 1 Guest(s)