08-14-2022, 02:10 PM
Although I'm a complete noob in electronics I did try to add a few resistors about a few hundred ohms (to both RX and TX), but nothing changed significantly.
But after I edited the configuration (the command line for the kernel) on the manjaro image and set the speed of the serial console to 9600bps I saw two lines[1] on the console: both mentioning something like "early hooks (udev)" and "early hooks (plymouth)".
I'll leave it for a night (again), but the board probably won't boot. I won't speculate what could possibly be wrong.
Well, that's as far as I can test.
[1] Some characters before those lines couldn't be printed, but I'm not worried about those.
Note: i'm using the woodpecker adapter and model A of the quartz64 board.
But after I edited the configuration (the command line for the kernel) on the manjaro image and set the speed of the serial console to 9600bps I saw two lines[1] on the console: both mentioning something like "early hooks (udev)" and "early hooks (plymouth)".
I'll leave it for a night (again), but the board probably won't boot. I won't speculate what could possibly be wrong.
Well, that's as far as I can test.
[1] Some characters before those lines couldn't be printed, but I'm not worried about those.
Note: i'm using the woodpecker adapter and model A of the quartz64 board.
