08-11-2022, 09:48 PM
Just got a model B and tried to do some verification. I have tried the following 2 images, but none of them is working correctly:
Manjaro-ARM-minimal-quartz64-b-20220808.img.xz: Serial output is entirely corrupted. It seems the system is booted into the OEM setup mode, and whenever I press the enter key it will immediately return some junk back. I assume it was asking for some question and won't take an empty response as answer, so it was asking again.
Armbian_22.08.0-trunk.0114_Quartz64a_jammy_edge_5.19.0.img.xz: No image for Model B from Armbian, so this A image has to do. The serial output is less corrupted with some recognizable words but far from a clean output. It is in a boot loop so not usable.
The serial cable and settings works correctly on a Radxa ROCK 4 so this has to be the board's issue right? (Right?) I tried to replace the DC power supply with another one with no avail since I think there might be some noise from the ground plane. They are 2 prong design though.
Manjaro-ARM-minimal-quartz64-b-20220808.img.xz: Serial output is entirely corrupted. It seems the system is booted into the OEM setup mode, and whenever I press the enter key it will immediately return some junk back. I assume it was asking for some question and won't take an empty response as answer, so it was asking again.
Armbian_22.08.0-trunk.0114_Quartz64a_jammy_edge_5.19.0.img.xz: No image for Model B from Armbian, so this A image has to do. The serial output is less corrupted with some recognizable words but far from a clean output. It is in a boot loop so not usable.
The serial cable and settings works correctly on a Radxa ROCK 4 so this has to be the board's issue right? (Right?) I tried to replace the DC power supply with another one with no avail since I think there might be some noise from the ground plane. They are 2 prong design though.
