RTL8370 Ethernet Switch Register Values
07-21-2021, 11:41 AM
I have a modified clusterboard using the original CAD, but cannot get any data over the network switch using default register values.
I've tried to get the values from the 24C08A SPI flash chip on an original board but broke it while removing it.
Is there a data file or documented register values available for the SPI falsh I can use?
The original board seems to need these parameters tow work both ways properly, so I suppose it is mandatory, unless there are some changes to the boot strap resisitors that would make it work at least at 100Mb/s.
Thanks!
I've tried to get the values from the 24C08A SPI flash chip on an original board but broke it while removing it.
Is there a data file or documented register values available for the SPI falsh I can use?
The original board seems to need these parameters tow work both ways properly, so I suppose it is mandatory, unless there are some changes to the boot strap resisitors that would make it work at least at 100Mb/s.
Thanks!