08-16-2021, 04:47 PM
Tks, ill see how that is done and give it a try. At this point its now a pretty paperweight ( its a nearly fresh install of Armbian buster on a new M.2, upgraded to Bullseye But that was before firmware, and was working no worse than before the OS rebuild. )
(08-16-2021, 03:41 PM)moonwalkers Wrote: Reset your OS touchpad settings to default. IIRC I had to pretty much disable noise cancelling in touchpad settings before, and after firmware upgrade I had to re-enabled it to make cursor less jumpy.