Hello,
https://yadi.sk/d/TfX6-MYy3RTf5h?w=1
I've updated the build again, this one is more plain but hopefully more stable, unfortunately for the r8156 it's defaulting to the in-tree cdc_ncm driver and openwrt doesn't have the easy way of copying the udev rule file over. I hear you guys, i'll put the patches out. It's just that they aren't very clean.
Have a go enabling threading perhaps, some drivers seem to allow it e.g:
echo 1 > /sys/class/net/eth0/threaded
echo 1 > /sys/class/net/eth1/threaded
Also note that when initially setting up interfaces you may need to reboot for everything to take effect. It seems like the ongoing persistent problem is when you try to use two usb nics off the usb3.0 port, especially if you are bridging / bridging vlans etc.
https://yadi.sk/d/TfX6-MYy3RTf5h?w=1
I've updated the build again, this one is more plain but hopefully more stable, unfortunately for the r8156 it's defaulting to the in-tree cdc_ncm driver and openwrt doesn't have the easy way of copying the udev rule file over. I hear you guys, i'll put the patches out. It's just that they aren't very clean.
Have a go enabling threading perhaps, some drivers seem to allow it e.g:
echo 1 > /sys/class/net/eth0/threaded
echo 1 > /sys/class/net/eth1/threaded
Also note that when initially setting up interfaces you may need to reboot for everything to take effect. It seems like the ongoing persistent problem is when you try to use two usb nics off the usb3.0 port, especially if you are bridging / bridging vlans etc.
