03-27-2021, 01:43 AM
Anyone have any type of update here?
I've got a few FDM printers and looking to try custom back cases.
I know that a few of the problems that have been identified are solvable, things like tabs should be able to be fixed by just adjusting the layer resolution, normally people print at .20mm or about that, and I've learned that for the really "good" prints I want to use, I'll lower the layer height to as low as .12mm, and even .08mm - It takes a LONG time to print, however, the quality is worth it.
I've got a few FDM printers and looking to try custom back cases.
I know that a few of the problems that have been identified are solvable, things like tabs should be able to be fixed by just adjusting the layer resolution, normally people print at .20mm or about that, and I've learned that for the really "good" prints I want to use, I'll lower the layer height to as low as .12mm, and even .08mm - It takes a LONG time to print, however, the quality is worth it.
