05-10-2016, 01:33 PM
(This post was last modified: 05-10-2016, 01:36 PM by DaveyDarko.)
The GPU is a Mali400 MP2, the video engine is CedarX. Drivers, and Linux in general, are still a work in progress as the PineA64 is very new and so is the arm64 port of Linux, in fact the RPi 3 still runs 32 bit Raspbian OS even though it is an arm64 SoC.
You should use at least a 5v 2a power supply, the RPi standard 2.5a supply is what I use through the micro USB when i power it that way, but it is probably better to supply power through the expansion header since the micro USB connectors are not rated for that much current, was a dumb idea in my opinion for both Pine and RPi to use the micro USB as a power connector.
You should use at least a 5v 2a power supply, the RPi standard 2.5a supply is what I use through the micro USB when i power it that way, but it is probably better to supply power through the expansion header since the micro USB connectors are not rated for that much current, was a dumb idea in my opinion for both Pine and RPi to use the micro USB as a power connector.
Currently playing around with Arduinos, CHIPs, Orange Pis, PineA64s, Raspberry Pis, etc.
