12-10-2020, 10:15 AM
Uploaded my version to https://www.thingiverse.com/thing:4681232
It printed really well! I still have some post-processing to do, but even without the rubber feet, it takes a lot to make it budge. It certainly doesn't topple over, either. The bracket's slots on the back turned out to be a wee tight for the matching tabs on the base, but I'm thinking about replacing those with a couple rails so the brackets can slide on/off, allowing you to swap between portrait and landscape holders. Might also figure out something to do for the dock, but I'm not sure what to do with that just yet considering the shortness and stiffness of its cable.
It printed really well! I still have some post-processing to do, but even without the rubber feet, it takes a lot to make it budge. It certainly doesn't topple over, either. The bracket's slots on the back turned out to be a wee tight for the matching tabs on the base, but I'm thinking about replacing those with a couple rails so the brackets can slide on/off, allowing you to swap between portrait and landscape holders. Might also figure out something to do for the dock, but I'm not sure what to do with that just yet considering the shortness and stiffness of its cable.
