11-22-2020, 02:32 PM
flashed jumpdrive to sd card using Etcher, boot off the card, jumpdrive says it's running. connected phone to laptop using the supplied red cable, but Etcher is finding no place to flash the new OS image. the phone storage doesn't show up with lsusb, either.
I'm using the Pinephone CE UBports edition, and have reset it to get rid of any settings that may interfere with this.
I've tried rebooting the laptop with the phone plugged in, I've tried rebooting the phone while plugged in, nothing.
the sd card seems to be good. Etcher reported no problems, and before flashing jumpdrive on it, I had stored a Mobian image on it which worked with no problems.
I'd really like to run Mobian off the emmc and I don't care how I get there, but I'm stymied. the mobian_installer utility fails, but that's for other reasons (it wants glibc 2.29, UBports is using glibc 2.23. I suppose I could try installing it by booting mobian from the sd card and then installing the OS from it, but installing a running OS just sounds like a recipe for disaster.
Any help would be gratefully appreciated.
I'm using the Pinephone CE UBports edition, and have reset it to get rid of any settings that may interfere with this.
I've tried rebooting the laptop with the phone plugged in, I've tried rebooting the phone while plugged in, nothing.
the sd card seems to be good. Etcher reported no problems, and before flashing jumpdrive on it, I had stored a Mobian image on it which worked with no problems.
I'd really like to run Mobian off the emmc and I don't care how I get there, but I'm stymied. the mobian_installer utility fails, but that's for other reasons (it wants glibc 2.29, UBports is using glibc 2.23. I suppose I could try installing it by booting mobian from the sd card and then installing the OS from it, but installing a running OS just sounds like a recipe for disaster.
Any help would be gratefully appreciated.
