3D Printed PinePhone stand

[simoni]

Works like a charm. I found the fit between the tabs and slots was very tight. Other than that all the other problems were my newness to 3D printing. I think I will try to add a CE Dock holder as my first 3D design task.  It has been a very steep learning curve. Picture taken with my Pinephone

Different printers have different tolerances; I tried to add a bit of slack into the slots; but it should be pretty clear in the OpenSCAD code what needs to change to make it even looser.

Anyway; glad it worked for you   If you add in additional bits for the CE dock then you are welcome to make a push request to the github repo (or just link to your design and I'll include it if you are not familiar with github).