Need some help on powering 16 PINEs

[rahlquist]

I'm a software guy.
I'm good at software engineering, and I have purchased 16 pines recently to run as a slave nodes in my cluster (using a 2xRaspberry Pi as main nodes).
Some academic stuff will be tested on this, later to be executed on Denmarks largest super computer, as part of my PhD.

The question is now: what's the wiring instructions for powering this cluster?
16 china-wall chargers next to each other, does sound like a nice way to burn down your house. So I'd rather not do that. Plus it's a wonky implementation.

I've been suggested this: http://www.amazon.com/Tanbaby-Switching-...typ_im_1_3

By user jproffer on here - and on several discussion threads online.
I see 2 terminals for +- and one for ground.
And then I see 2 terminals for connecting a 230V mains cord, which does worry me a little as I have little to no experience with wiring stuff, so my instinct tells me that working with lethal shock dangers like this, isn't good practice.

However, I do need this cluster powered.

Those 4 terminals I see: 2 for plus, 2 for minus.
How do I expand those into the 16 that I need?
What do I wire into ground..?

Could anyone explain this in a very dummy way to me?

There is a lot of ways you could do this. Looks very similar to this http://www.aliexpress.com/item/High-Qual...53000.html which has better pcitures. So I will make the assumption that it is a similar hookup.

If that is the case looking at the connections your Pine will be connected to the V+ and V- connection. I would recommend avoiding the USB port completely and wire them all through one of the bus connectors. Probably on the Euler bus, looks like pins 2 and 4 are voltage in. Then pick a ground on the Euler bus http://files.pine64.org/doc/Pine%20A64%2...160119.pdf

The remaining leads on the power supply are 7 Earth Ground, 8 Neutral, 9 Line. Those go to your AC source. 

Always test everything with a meter before hooking it to anything.

Hey. Thanks for your reply.

A few followup questions, and yes, it is the very same model as the one you linked:
V+ goes to pin 2 and V- goes to pin 4?
Then it looks like pin 6 is ground, so I hook ground there?

My AC source would be a wall plug. How on earth I'll get a earth ground, a neutral and a line there is beyond me. Keep in mind I've never touched a wire before.
I know these terms, I just don't know what they really mean.

I did buy myself an expensive meter, in order to not fry the entire rack.

The V+ should go to the Euler connector 2 or 4 or both. The V- should go to 6, 9, 14, 20, 25, or 34. Please lets have someone else verify this sounds right tkaiser perhaps. 

On the AC side. The Line should go to HOT as shown on this page http://inspectapedia.com/electric/Electr...ctions.php (the narrow blade in a US outlet) The N should go to Neutral (the wide blade in a US outlet). Earth Ground is the 3rd prong at the bottom. 

Please use extreme care when working with electricty of any type if you haven't had formal training as it can easily kill you.