UPDATED (June 2021): 17-distro multi-boot image for Pinephone (incl. 3GiB variant)

[joz_mak]

Newbie has problem installing the multiboot image

I followed the installation instructions on the developer's blog.
The installation of the image went without a glitch except when I resized the card the output didn't show the size of the card as was described in the installation instruction.

[jmak-pc Documents]# mount /dev/sdb2 /mnt
[jmak-pc Documents]# btrfs filesystem resize max /mnt
Resize '/mnt' of 'max'
[jmak-pc Documents]# umount /mnt
[jmak-pc Documents]# df -h
Filesystem      Size  Used Avail Use% Mounted on
dev            3.9G    0  3.9G  0% /dev
run            3.9G  1.7M  3.9G  1% /run
/dev/sda3        30G  23G  5.2G  82% /
tmpfs          3.9G  213M  3.7G  6% /dev/shm
tmpfs          4.0M    0  4.0M  0% /sys/fs/cgroup
tmpfs          3.9G  8.6M  3.9G  1% /tmp
/dev/sda1      549M  70M  480M  13% /boot/efi
tmpfs          784M  104K  784M  1% /run/user/1000

The image boots up fine but I can't select any of the listed distros. The screen gets frozen and after a few seconds the phone shuts down.
The size of my sdcard is 64 gig.

Could anyone give me a clue how to fix this issue?

Thanks a lot.

I managed to make it work. I don't know how to remove this post.

Moderator note: Deleted post for you.