07-31-2020, 05:02 PM
(07-31-2020, 01:11 PM)biktorgj Wrote: 3. Since the flashlight is soldered to the main PCB there's no way of moving the back camera to the case, so I would leave that section covered by a new (thinner) middle frame and let the slider keyboard begin from below the camera, instead of covering _all_ of the backside of the phone (imagine the droid Razr Maxx (https://fdn2.gsmarena.com/vv/pics/motoro...maxx-1.jpg), but the moving parts would be just below the camera
I am in agreement with 1&2. For 3 you would basically not have a flat surface on the back? Or you would have a cover so the back would be flat, with just a pass through for the camera? But then the keyboard would be restricted in width?
I see why you say that and the logic behind it.
