04-12-2020, 05:35 AM
(12-22-2018, 03:44 PM)tuxd3v Wrote:(12-22-2018, 05:29 AM)va88 Wrote: Could this possibly work on a Rock64?
At the moment it wouldn't work, in future releases perhaps..
I am redesigning the Backend of ATS, so accept different input sources and different output sources.
But the most important are SysFs and PWM..
In Rock64 I don't know if there are any pwm driver there, or if there are any fan conector..
It could be possible to generate the pwm, via GPIO, but a HardWare power driver( like in Rockpro64 need to exist in some form to switch the fan On/Off ).
It could be even a breakout board connected to gpio and 12 volts, receiving pwm from ATS for example..
I don't know much about rock64
Someone managed to get this to work with Rock64?
I have a case from C4Labs with a CPU fan, but the fan runs at full speed the whole time and is very noisy.
I also don't know about any PWM drivers.
It doesn't look like that this board has any fan connector, here is a pdf of the pins:
http://files.pine64.org/doc/rock64/ROCK6...5+_Bus.pdf
I am a noob concerning electronics, which kind of breakout board do I need, can you please give me an example for what I should look for?
Maybe something like this:
https://www.ebay.de/itm/Automatic-Temper...Sw5HBbSFyA
This board works even without ATS, right?
My fan only has two pins, do I need a 4 pin to 2 pin adapter to connect to Fan1 on this board?
And for what is the black cable of this board? For the information of the CPU heat of the Rock64?
