PINE64   ›   Pinebook Pro   ›   Linux on Pinebook Pro   ›   Using UART

Thread Closed 
Using UART
pfeerick
Moderator
*****
Moderators
Joined: May 2016
Posts: 1,361

Reputation: 118
#9
11-19-2019, 09:08 PM
What, didn't you have your invisible ink glasses on? :-P

If it survived, then all good. Looks like you have a cable that isn't using a RS-232 driver with built-in step-up (in the order of 30v... from -15 to +15... but typically nearer to 25v) Wink
pine64 wiki, linux-sunxi Pine64 wiki, the board/connector layout & pinout of the Raspberry Pi/Euler/EXP connectors
Thread Closed 


Messages In This Thread
Using UART - by VoxUnius - 11-19-2019, 07:39 AM
RE: Using UART - by neilman - 11-19-2019, 08:15 AM
RE: Using UART - by VoxUnius - 11-19-2019, 08:35 AM
RE: Using UART - by neilman - 11-19-2019, 10:12 AM
RE: Using UART - by xalius - 11-19-2019, 03:27 PM
RE: Using UART - by VoxUnius - 11-19-2019, 04:02 PM
RE: Using UART - by pfeerick - 11-19-2019, 05:03 PM
RE: Using UART - by VoxUnius - 11-19-2019, 05:57 PM
RE: Using UART - by pfeerick - 11-19-2019, 09:08 PM
RE: Using UART - by VoxUnius - 11-20-2019, 12:02 AM
RE: Using UART - by pfeerick - 11-20-2019, 02:40 AM
RE: Using UART - by VoxUnius - 11-21-2019, 10:58 PM
RE: Using UART - by pfeerick - 11-22-2019, 03:38 AM
RE: Using UART - by Arwen - 11-22-2019, 05:01 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Repurpose debug UART as GPIO wishindo 3 1,503 04-13-2023, 07:10 AM
Last Post: KC9UDX

Forum Jump:


Users browsing this thread: 2 Guest(s)