11-04-2019, 11:24 AM
(11-04-2019, 09:43 AM)Luke Wrote:(11-04-2019, 07:48 AM)tophneal Wrote: I'm assuming it'll be fine to use a low tack glue to keep these standoffs where they belong, when disassembling?
Be careful taking off the bezel around the LCD. Its held in place using not only the 4 screws behind the stand-offs but also a bunch of plastic tabs. Make sure those tabs don't snap when you slide your guitar pick between the bezel and the metal lid.
But, yes, a small drop of low tack glue will work fine.
Out of curiosity, the small standoffs you hightlighted in the wiki, are they part of the NVMe/trackpad contact solution that arose before shipping? When I last opened mine to disable the eMMC and boot from SD, they came out and I couldn't determine where they went so I put them off to the side and reassembled. After finding this post, I checked my PBP to make sure the lower casing wasn't loose or sitting incorrectly, it showed no issue and it got me wondering.