12-15-2018, 12:31 PM
(12-15-2018, 08:18 AM)huey Wrote: Using the same card but from IOCREST (same id's) but can not get it working. Followed same steps I think: SD Card with minimal bionic 7.9.0 (?) and switched mainline kernel 4.19.0-1073. But with and without udev rule it will not see my disk. I checked voltage on the power...
If I try to run eMMC image and switch to mainline kernel my rockpro does not boot anymore... keeps complaining and looping about EQC error?
Tried to use serial console to see boot from the start, but that only gives me garbled code??
Is the pcie only visible with the mainline kernel or does someone have an easier route to a working adapter for me available?
Pfff, not sure what to do to understand whats wrong.
Regards
I'm assuming that the controller is working and you have checked vendor and device id with lspci. You've probably already done it but just to be sure: Check power and data cable connections once more on both RP64 and the drive. Check the data cable and drive on PC or some other device if possible. If none of these help I'm out of ideas.
About eMMC card I'd guess you're having 32GB Foresee (so some other card that supports command queueing). In that case the problem is that command queueing doesn't work and has to be disabled with a kernel patch. See discussion on another thread and couple of link to different patches:
- https://forum.pine64.org/showthread.php?...2#pid40442
- https://github.com/nuumio/ayufan-rock64-...f97c82e2a3
- https://github.com/nuumio/ayufan-rock64-...582380766d
For serial console my guess would be wrong settings. They should be 1500000 8N1. I made a mistake the first time and missed one zero
