10-08-2018, 04:24 PM
(10-05-2018, 05:14 PM)Mpoint Wrote: The Photon has been connected to Rock64 via TX and RX pin crossover at each end.
But I am not getting any message on the serial console here is the attached putty and mincom console screen
https://ibb.co/mxYpJe
Connection
Rock 64 Photon Nextion Display
GPIO6(gnd)-------gnd pin------------Gnd pin
GPIO8(TX)---------RX pin-------------TX pin
GPIO10(RX)-------TX pin-------------RX pin
Here is the circuit diagram using Fertilizing https://ibb.co/ebtOeU
The code is located in the Photon Memory and it send data via serial com to both RX pins (rock64 and Nextion display) the nextion touch display acts as a control panel for photon
I'm confused - are you trying to use the photon to see what the Rock64 is doing, or are you trying to use the Rock64 to see what the photon is doing? (I don't know anything about the photon but I assume it works like an Arduino).
