09-25-2018, 03:08 AM
(09-24-2018, 04:31 PM)mmatyas Wrote: Hello,
I got the following SATA controller card with the Marvell 88SE9230 chipset working: https://www.amazon.de/gp/product/B01ENKQ...UTF8&psc=1
The trick was to put pci=nomsi into the kernel boot parameters in /boot/extlinux/extlinux.conf
(also, before you start looking for driver errors for hours, check if your hard disks are actually working, a defective one cost me n hour of debugging today)
Ok, I will try that.
Until now when I do a coldboot (I plugin the powersupply and then hit the powerbutton) I see the three leds on de pcie card light up, but I get an error message and the system hangs (see picture attached).
error messag PCIe
When I then reset the system (~warmboot) the three leds light up for second and then go out, and the pcie card gets extremely hot. Eventually the system hangs with a kernelpanic again.