03-05-2018, 02:34 AM
I would like to use an old Raspberry Pi 1B (with a PiFace digital card) to monitor my Rock64 board. Therefore I'm using the serial to USB adaptor (shipped from pine64) to connect the Rock64 to the USB2 port of the RPi1.
Unfortunately the USB2 port of the RPi1 seems to be too slow to handle the 1.5M baud rate delivered by the Rock64 as I have some data skipped/ dropped.
Is there a simple way to reduce the baud rate or do you have any other idea how to handle this?
I would like to use this combination of hardware because (I have it already at home) despite of monitoring via UART, with the PiFace board I can remotely reset and/or power off devices...
Thanks for your help!
Cheers Martin
Unfortunately the USB2 port of the RPi1 seems to be too slow to handle the 1.5M baud rate delivered by the Rock64 as I have some data skipped/ dropped.
Is there a simple way to reduce the baud rate or do you have any other idea how to handle this?
I would like to use this combination of hardware because (I have it already at home) despite of monitoring via UART, with the PiFace board I can remotely reset and/or power off devices...
Thanks for your help!
Cheers Martin