08-17-2017, 04:52 AM
(This post was last modified: 08-17-2017, 04:56 AM by MarkHaysHarris777.)
Basically, on the production boards they tied the usb power through regulators; two GPIO lines must be toggled to set the regulator or the usb power drops. For some reason the gpio mux lines controlling the regulators are left floating; not good.
There are two ways to fix it: 1) dts|dtb , or script , to toggle the mux lines turning the regulators ON, or 2) mod the board so that the regulators are ON all the time !
The regulators are on the schematic on page 19; We'll do some testing and see if we can get a software fix; otherwise, we'll put up a board mod procedure.
There are two ways to fix it: 1) dts|dtb , or script , to toggle the mux lines turning the regulators ON, or 2) mod the board so that the regulators are ON all the time !
The regulators are on the schematic on page 19; We'll do some testing and see if we can get a software fix; otherwise, we'll put up a board mod procedure.
marcushh777 
please join us for a chat @ irc.pine64.xyz:6667 or ssl irc.pine64.xyz:6697
( I regret that I am not able to respond to personal messages; let's meet on irc! )
please join us for a chat @ irc.pine64.xyz:6667 or ssl irc.pine64.xyz:6697
( I regret that I am not able to respond to personal messages; let's meet on irc! )
