10-02-2016, 04:01 AM
(10-01-2016, 11:58 PM)dkryder Wrote: seems like you are not the only one.
https://github.com/resin-io/etcher/issues/573
they tried closing a few times in july, then did close 8/02, so it seems they did that too early unless you are using an older version
Looks like they may have introduced a better one, unless my case was an oddball one due to upgrading... I had validation errors at about 13%... so I took my business elsewhere (Rufus) and didn't regret it! I suppose if it is going to have a dummy spit, at least it didn't leave me hanging for the 99% failure! :-D
@Topgun505 Don't worry mate... you'll be doing a lot of learning... these SBC (single-board computers) are an quite a different beast to your average x86/PowerPC/AMD computer!!!
Keep on asking questions, and we'll do our best to lead you astray.... er, help you out!
