My Board Layout Diagram

[UnixOutlaw]

Its rather busy, isn't it?

The diagram fails to highlight power on euler 4&6; uart3&4 are not highlighted, uart0 (shown accessed on euler) is better accessed on the EXP header 7 8 &9, uart2 on PI is not highlighted, and the overall pinouts diagrams (located here on the wiki) are really too small, aren't they?

This chart is a galant effort, and if it helps you fine, but it seems too specific to be useful generally, and is just busy enough to be really confusing specifically;  which can raise more questions than it answers. On the other hand, it just may come in useful for lots of people (time will tell).

---

edit:  PS   Also, if you would post your pics the way I told you to, you would be able to upload your content, the pics would show as thumb-nails (which makes them easier to read by everyone), and the expanded pics would have a better resolution.

I will post specific instructions as a sticky tomorrow.

The Pine64+ system-board itself is rather "busy"...    Also - I'd rather be advised, coaxed, persuaded, I'm an "actual real" Outlaw and don't like being "told"   - and most of the "busyness" is the tables which are screen grabs from the PDF document from Pine itself...  The diagram is mostly for my own use - yes - but I really could have done with something like this months ago...

As I posted in one of the lower paragraphs in my original post above - I'm probably not going to label/document any of the PINs I'm not using...but I may update with labels for the RESET switch on the EXP headers - however - I'm still confused - if I jumper a switch via EXP PIN4 - where do I jam the other side?

Here's it updated with the bitmaps removed :