08-01-2016, 09:44 PM
Okay - so I flipped over the jumper - to the other poles - and still no go...
Powers up on USB DC in - battery shows connected and charged - pull USB power out and the thing goes black!
Is this a software thing? What gives? What's the point of charging a battery if you can't run on it?
I'm yet to test in Linux - but I will be mighty annoyed if I can't run either of my Pines on battery!
Also - are there any AXP (I think I read somewhere about Pine using AXP209) scripts to monitor battery from Linux?
Powers up on USB DC in - battery shows connected and charged - pull USB power out and the thing goes black!
Is this a software thing? What gives? What's the point of charging a battery if you can't run on it?
I'm yet to test in Linux - but I will be mighty annoyed if I can't run either of my Pines on battery!
Also - are there any AXP (I think I read somewhere about Pine using AXP209) scripts to monitor battery from Linux?