07-11-2016, 02:56 PM
(This post was last modified: 07-11-2016, 03:14 PM by amc2012.
Edit Reason: Updating test results
)
I have the PINE64 connected to a Linksys EG005W Gigabit switch (along with a desktop computer which is fine in Gigabit mode), which goes down to a JGS524 Netgear router in the wiring closet. Behind that is an ASUS TM-AC1900 T-Mobile router running firmware 3.0.0.4.376_3169 and behind that is an ActionTEC MI424WR FiOS router running in bridge mode.
I'm going to try swapping out the Linksys to see if there is any difference.
UPDATE 1: Nope. It's not the Linksys. Will try the Netgear now.
UPDATE 2: Nope, it's not the Netgear either. Seems odd that it would be something further down the line. I can't even connect to it inside my own network if it's in gigabit mode, and I'm even on the same local switch. Seems to be an issue with the PINE64 itself. I'm open to any other suggestions as to what to try. I also tried several different cables.
I'm going to try swapping out the Linksys to see if there is any difference.
UPDATE 1: Nope. It's not the Linksys. Will try the Netgear now.
UPDATE 2: Nope, it's not the Netgear either. Seems odd that it would be something further down the line. I can't even connect to it inside my own network if it's in gigabit mode, and I'm even on the same local switch. Seems to be an issue with the PINE64 itself. I'm open to any other suggestions as to what to try. I also tried several different cables.