Ok seen image finally , have spun cable around so it sticks out side. Hope to see drastic wifi improvement
Stuck mine down outside case made NO diff to signal strength, basically getting no bars on wifi readout
(07-06-2016, 11:49 AM)Ghost Wrote:(07-06-2016, 07:13 AM)grantos Wrote: Cable is attached to module but not sure where to glue/stick other end that had 3M tape?
As far from the board as possible (which isn't that far, because the cabling isn't too long).
Mine is stuck to the acrylic case and works ok.
Stuck mine down outside case made NO diff to signal strength, basically getting no bars on wifi readout