06-21-2016, 09:52 PM
So just got my pine. Pretty pumped to finally get it! But having an issue. I got the 512 board with the power cable and sd card with Android on it. Did the first boot up and left for an hour. Initially I had evening plugged in(usb and Ethernet) but I didn't know I wasn't supposed to, Before reading up on that issue I just formatted the sd card and put the Android dd on the sd card with that win32 program (on my phone at work.). While it was writing the dd i read up on some issues and saw that you should do first run 26th just hdmi and power. So after the dd finished writing i put it back in the pine and booted it up again. This time with nothing but the hdmi. The Android logo is all fuzzy and that's as far as I get. I left it for 4 hours and nothing changed. I than tried Phoenix and wrote it as start up and same thing. Occasionally I'll get a white screen for sec but than just a fuzzy square. I'm using the images off the wiki and my tv can do 1080@60hz.
Any help would be great. Thank you
Any help would be great. Thank you