08-07-2026, 05:15 AM
(08-31-2023, 09:47 AM)erikzoltan Wrote: I am using version 4.26.1.
I will try the version you suggest. Thanks so much for the tip!
I have written WaspOS reload-mcuboot.zip via gadgetbridge, but it turned to dfu boot mode.
This was because I did not upload micropython.zip.
I have installed nrfconnect via google store, and connected pinetime-dfu well.
But it failed uploading micropython.zip.
It reaches 100% in a minute, but it did not disconnected nor wrote.
But If I downloaded nrfconnect 4.26.1 via github, It wrote micropython.zip well and slower than most recent nrfconnect.
And it disconnected well when it finished uploading.
If it bootloops, you must push a button once till it turns to dfu mode which shows "start" and bluetooth mark in lower right corner.
Pushing timing to change into dfu mode is somewhat tricky.
