02-07-2025, 10:51 AM
Hello Pine64 Team,
I am a big fan of your open-source projects, and I would love to use the Pinecil V2. However, due to customs restrictions in Turkey, I am unable to import it into my country.
To overcome this issue, I would like to manufacture a Pinecil V2 unit for my personal use only. I have found the schematic and PCB placement files, but I need the Gerber files to proceed with PCB fabrication.
Since Pinecil is an open-source project, I was wondering if you could provide the Gerber files for Pinecil V2 or guide me on how to generate them from the available resources.
Thank you for your time and for supporting open-source hardware!
Best regards
I am a big fan of your open-source projects, and I would love to use the Pinecil V2. However, due to customs restrictions in Turkey, I am unable to import it into my country.
To overcome this issue, I would like to manufacture a Pinecil V2 unit for my personal use only. I have found the schematic and PCB placement files, but I need the Gerber files to proceed with PCB fabrication.
Since Pinecil is an open-source project, I was wondering if you could provide the Gerber files for Pinecil V2 or guide me on how to generate them from the available resources.
Thank you for your time and for supporting open-source hardware!
Best regards
