A way to view or log the splash screen on Pinephone Pro running ArchLinux (Danctnix)

[PHLEMON]

I do remember a long time ago that I got duplicate connections on nmcli that were stepping on one another.

run command 

Code:

nmcli connection show

Thanks for this man, was able to see the different UUIDs for each saved networks. However, nothing appeared as duplicates even after 'nmcli con delete UUID' and reconnecting. 

I was able to view the splash screen by crudely taking a video of my PPP at boot-up using my other phone. The error showed up to be "ov8850 1-0036: Failed to read reg 208906: -6" "Probe with driver: driver imx258 failed with error -5. or failed to read chip id 258" both ov8850 and imx258 turns out to be the driver for the camera modules of the PPP which is unrelated to my concern. 

I think these logs would be relevant: 
Upon "sudo dmesg | grep -i sdio" 
Output: 
[ 6.653028] brcmfmac mmc0:0001:1: Direct firmware load for brcm/brcmfmac43455-sdio.pine64,pinephone-pro.bin failed with error -2

Upon "sudo journalctl -u NetworkManager -f"
Output: 
Jul 29 01:54:28 danctnix NetworkManager[3797]: <info> [1722189268.9366] device (wlan0): supplicant interface state: scanning -> associating 
Jul 29 01:54:28 danctnix NetworkManager[3797]: <info> [1722189268.9368] device (p2p-dev-wlan0): supplicant management interface state: scanning -> associating 
Jul 29 01:54:29 danctnix NetworkManager[3797]: <info> [1722189269.0558] device (wlan0): supplicant interface state: associating -> disconnected 
Jul 29 01:54:29 danctnix NetworkManager[3797]: <info> [1722189269.0561] device (p2p-dev-wlan0): supplicant management interface state: associating -> disconnected 
Jul 29 01:54:29 danctnix NetworkManager[3797]: <warn> [1722189269.4720] device (wlan0): Activation: (wifi) association took too long 
Jul 29 01:54:29 danctnix NetworkManager[3797]: <info> [1722189269.4723] device (wlan0): state change: config -> need-auth (reason 'none', sys-iface-state: 'managed') 
Jul 29 01:54:29 danctnix NetworkManager[3797]: <warn> [1722189269.4747] device (wlan0): Activation: (wifi) asking for new secrets

Upon "sudo dmesg | grep -i brcmfmac"
Output: 
[ 7.041425] brcmfmac: brcmf_fw_alloc_request: using brcm/brcmfmac43455-sdio for chip BCM4345/6 
[ 7.082935] usbcore: registered new interface driver brcmfmac [ 7.236643] brcmfmac: brcmf_c_process_txcap_blob: no txcap_blob available (err=-2) 
[ 7.238651] brcmfmac: brcmf_c_preinit_dcmds: Firmware: BCM4345/6 wl0: Apr 15 2021 03:03:20 version 7.45.234 (4ca95bb CY) FWID 01-996384e2 
[ 12.117766] brcmfmac: brcmf_set_channel: set chanspec 0x100c fail, reason -52 
[ 12.126424] brcmfmac: brcmf_set_channel: set chanspec 0x100d fail, reason -52 
[ 12.135012] brcmfmac: brcmf_set_channel: set chanspec 0x100e fail, reason -52
and so on... repeating the "chanspec fail, reason -52"

Upon "sudo modprobe -r brcmfmac && sudo modprobe brcmfmac"
Output: 
modprobe: FATAL: Module brcmfmac is in use.

I'll try looking for other solutions specifically on chanspec reason -52 (Although I don't see this issue happening on PPP but on Raspberry Pis)

Hopefully you know something about this. But if all fails, I might go reinstalling the OS.