SATA hotplug not working?

[JPT223]

Hi,

I set up a NAS but I realized SATA hot plug is not working.
Is it a limitation of my SATA adapter or doesn't it work in general?

Looks like I got a ASM1166 chip, but this is odd because the chip got 6 SATA lines but my card has 8 sockets.

this adapter is not optimal because it uses only 2 PCIe-Lanes.
I probably should by a new one. it was cheap, though



thanks
JPT

Code:

01:00.0 SATA controller: ASMedia Technology Inc. ASM1166 Serial ATA Controller (rev 02) (prog-if 01 [AHCI 1.0])        Subsystem: ASMedia Technology Inc. ASM1166 Serial ATA Controller        Flags: bus master, fast devsel, latency 0, IRQ 50        Memory at fa080000 (32-bit, non-prefetchable) [size=8K]        Memory at fa082000 (32-bit, non-prefetchable) [size=8K]        Expansion ROM at fa000000 [virtual] [disabled] [size=512K]        Capabilities: [40] Power Management version 3        Capabilities: [50] MSI: Enable+ Count=1/1 Maskable- 64bit+        Capabilities: [80] Express Endpoint, MSI 00        Capabilities: [100] Advanced Error Reporting        Capabilities: [130] Secondary PCI Express        Capabilities: [170] Latency Tolerance Reporting        Capabilities: [200] L1 PM Substates        Kernel driver in use: ahci