06-22-2023, 12:22 PM 
		
	
	
		I have several Pine 1 boards.  In the process of setting Static IP addresses on one of the Pine 1 boards I have managed to brick it.  I have setup two other Pine 1 boards successfully so they book and I can ssh into them.  But in the third Pine 1 I have gotten it into a condition where the board comes up running Ubuntu using Ambian.  At boot a page of output appears in the HDMI console and then the screen goes black and ultimately shows a "No Signal" message.  I tried re-flashing the sd card I am booting from but had the same results.  Is there a way to return the board to the factory condition? Thanks for any help.
	
	
	
	
	


