+- PINE64 (https://forum.pine64.org)
+-- Forum: PINE A64(+) (https://forum.pine64.org/forumdisplay.php?fid=4)
+--- Forum: Linux on Pine A64(+) (https://forum.pine64.org/forumdisplay.php?fid=6)
+---- Forum: Ubuntu (https://forum.pine64.org/forumdisplay.php?fid=27)
+---- Thread: Pine 1 will no longer boot (bricked) (/showthread.php?tid=18401)
Pine 1 will no longer boot (bricked) - dstallmo - 06-22-2023
I have several Pine 1 boards. In the process of setting Static IP addresses on one of the Pine 1 boards I have managed to brick it. I have setup two other Pine 1 boards successfully so they book and I can ssh into them. But in the third Pine 1 I have gotten it into a condition where the board comes up running Ubuntu using Ambian. At boot a page of output appears in the HDMI console and then the screen goes black and ultimately shows a "No Signal" message. I tried re-flashing the sd card I am booting from but had the same results. Is there a way to return the board to the factory condition? Thanks for any help.