No just the barrel jack, I actually haven't used USB-C to charge yet
edit:
I had to swap GPIO2 with RX since GPIO2 is high on boot and high side relay was being triggered.
I am now using RX pin and setting it to low in setup... this seems to be stable.
Now I just gotta think about the charging logic since it's weird to have it turn off at 80% then 5 minutes later say it's 78% start charging again to get back to 80%.
edit:
I had to swap GPIO2 with RX since GPIO2 is high on boot and high side relay was being triggered.
I am now using RX pin and setting it to low in setup... this seems to be stable.
Now I just gotta think about the charging logic since it's weird to have it turn off at 80% then 5 minutes later say it's 78% start charging again to get back to 80%.
