Pinephone Pro does not start with RE button pressed

[emsyr]

Is there any news? I'm quoting the following notes from Tow-Boot instructions that are relative to unsuccessful try to boot from SDcard in Pinephone Pro:

NOTE: Reminder that at this point you should be holding the RE button until the phone vibrates and the LED lights up red.

TIP: It may be easier to connect the phone to a power source via USB instead of pressing the power button.

WARNING: Make sure you are holding the RE button before either powering-on using the power button or by connecting to a power source.

When starting up with Tow-Boot, which the installer image use, the phone will vibrate slightly and the LED will turn red. After a short moment, the LED should turn yellow.

Sometimes, removing the battery and pressing the Power Button for about 10 to 20 seconds in order to fully discharge the device resolves issues related to starting up or booting.