Pinephone Pro does not start with RE button pressed
#4
(08-30-2022, 10:07 PM)shulamy Wrote:
(08-29-2022, 09:29 PM)c0ssan Wrote: Hello,

Not sure what I'm doing wrong, but my Pinephone Pro does not start with RE button pressed in order to boot from SD card.  

I just want to install Tow-Boot.


Thank you!

 i don't know about pro but pinephone boots from sd first

 are you sure the sd has boot loader on it ?

 and usually  mmcblk2 is the sd so the phone still boots from emmc

 did you check with fdisk?
 
 ezik

The PinePhone boots from SD first, but the Pro doesn't.

The common causes of failure to boot from uSD are using a non-Pro PinePhone image in a Pro, and writing the image to the uSD incorrectly, such as to one of the partitions rather than the raw device. Always worth double checking the basics.
  Reply


Messages In This Thread
RE: Pinephone Pro does not start with RE button pressed - by wibble - 08-31-2022, 11:54 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
Question The PPP behaves as if the volume button is pushed all the time, how fix? guru 2 7,219 09-01-2025, 04:07 AM
Last Post: teekay
  PinePhone Pro: Camera App very laggy Martin87 3 3,574 08-22-2025, 11:23 PM
Last Post: teekay
  PinePhone Pro discontinued teekay 9 3,195 08-22-2025, 11:19 PM
Last Post: teekay
Exclamation Pinephone Pro wont boot to anything! Supervisor 5 1,019 08-18-2025, 06:15 PM
Last Post: KC9UDX
  Pinephone pro ee bricked? dennylee 3 897 07-22-2025, 12:06 AM
Last Post: Dendrocalamus64
  Full desktop Surfing and Absolute Privacy on the pinephone? Www 8 1,493 06-30-2025, 10:51 AM
Last Post: Dendrocalamus64
  Backing up data on Pinephone Pro to hard disk, optical disk and flash? Www 4 998 06-29-2025, 02:46 PM
Last Post: Dendrocalamus64
  Printing and scanning documents with pinephone? Www 4 1,025 06-29-2025, 11:48 AM
Last Post: biketool
  FM? A future new PinePhone? jebez 1 744 06-26-2025, 11:47 AM
Last Post: zetabeta
Information Fix PinePhone Pro when unable to boot due to drained battery butjar 8 10,914 03-13-2025, 08:40 PM
Last Post: pcb

Forum Jump:


Users browsing this thread: 1 Guest(s)