01-28-2022, 12:01 AM
(01-24-2022, 10:49 PM)bcnaz Wrote: @HLing
It may be a good idea to look closer at some of the posts (in this forum) from the UBPorts era, actually describe the fault or check the forum wiki.
As the keyboard is connected via the POGO pins, NOT usb, so it may not be affected ?
I currently have my new keyboard attached to a PMOS Convergence phone, and I seem to remember that PMOS release had some similar usb fault mentioned in posts.
The keyboard is doing ok on this phone, besides a few firmware problems within the keyboard itself, discussed in other posts.
----> ((keyboard is fun and triples your runtime))
So I think it would work, but...
" " Maybe start a thread asking if someone has a working keyboard on a UBPorts phone" " ?
For usb thethering necessity I am still using the stable version. ("uname -a"gets: Linux Mobian 5.10-sunxi64 #2 SMP PREEEMPT Tue Jan 12 09:55:56 UTC 2021 aarch64 GNU/Linux, which to my surprise had another update last December. )
First I tried to get a better contact by 1) fully charged and then power off my Pine phone. 2)pressing the Keyboard case and hearing the clicks. 3)connecting the USB-C port on the keyboard to a PD charger. 4) green light lit up. 5)keep it connected overnight. The next morning, i powered on pine phone. It only has 35% power from 100% night before. Nothing happens with the keyboard.
Today I booted from a micro SD that had the weekly from Jan 16, 2022, which after unzipping seemed to have 6 G of data?! I ran the update using the wifi since the sim card was not seen by the phone. This is Book Worm, kernel 5.15? The Mobile network did not come on for a while, but it eventually appeared so I could set up Mobile data and roaming. Phone call did not work. I dial and nothing happens, even though in the "recent" it showed that I tried to call out. The mobile data seemed on, but i wasn't able to get online with firefox. The last thing that did it was that the charging was not taking a PD charger. All of the above just worked on my Mobian Bullseye. Plus i did not have the keyboard case with me to test it.
I might just stay with my current configuration for a bit more.
