PINE64   ›   ROCK64   ›   Rock64 Hardware and Accessories   ›   USB3 to SATA cable - Firmware

USB3 to SATA cable - Firmware
Eule
Pine Initiate
**
Joined: Mar 2020
Posts: 1

Reputation: 0
#1
03-03-2020, 01:31 PM
Hello everybody,

I have a USB3 to SATA cable with JMS578 and firmware version v0.4.0.9.
Unfortunately I am not able to use hdparm to detect drive state (= unknown). I also would like to control spindown.

I found several threads which recommends to update to firmware version v173.1.0.1 from here: odroid wiki

What do you think about it?

Best regards
Oliver
  Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
Information How to Setup Serial Console Cable Over the Rock64 SBC MarkHaysHarris777 10 41,586 03-24-2025, 06:35 PM
Last Post: arunkhan
  USB3 SATA ReleaseTheGeese 2 4,115 04-04-2021, 12:55 PM
Last Post: ReleaseTheGeese
  USB3 enough to power 2,5 external HDD? va88 11 19,180 06-06-2019, 03:40 PM
Last Post: va88
  PCIe extender cable for M2 grimace 1 3,399 02-15-2019, 11:15 AM
Last Post: fonix232
  Does the Pine usb to sata adapter work with hd-parm? FabrizioMaurizio 0 2,499 02-06-2019, 11:37 AM
Last Post: FabrizioMaurizio
  GPIO extension cable fault viguzzz 12 18,653 05-18-2018, 04:03 AM
Last Post: viguzzz
  unable to switch usb3 ports on cglhu 6 11,070 05-17-2018, 08:43 AM
Last Post: cglhu
Bug Rock64 Boot-up Bug with Serial Console Cable MarkHaysHarris777 1 8,845 04-13-2018, 03:45 AM
Last Post: Z80
  USB 3 2.5" SATA Case thewonderer 2 4,979 12-13-2017, 06:05 PM
Last Post: thewonderer
  Best USB3.0 to SATA bridge mikedhoore 6 19,824 10-02-2017, 07:52 AM
Last Post: mikedhoore

Forum Jump:


Users browsing this thread: 1 Guest(s)