11-09-2022, 05:44 AM
(This post was last modified: 11-09-2022, 07:27 AM by moxx.
Edit Reason: New informations
)
Playing around with the sensors I found out that the magnetometer is missing in /sys/bus/iio/devices, while accelerometer, proximity/light sensor and charger are there.
dmesg tells this:
Seems like the driver could not start. Does anyone have a similar issue?
//edit: Very interesting: If I boot the Pinephone with the Lora Backplane, the magnetometer shows up successfully. Maybe this thread should be moved to the Hardware-Topic
dmesg tells this:
Code:
[ 18.550161] iio iio:device0: DRDY on pin INT2 specified, but sensor does not support interrupts
[ 18.550453] axp20x-battery-power-supply axp20x-battery-power-supply: DMA mask not set
[ 18.566730] axp20x-adc axp813-adc: DMA mask not set
[ 18.592344] iio iio:device0: interrupts on the rising edge
[ 18.598297] gpio gpiochip2: (1c20800.pinctrl): gpiochip_lock_as_irq: tried to flag a GPIO set as output for IRQ
[ 18.608472] sun50i-a64-pinctrl 1c20800.pinctrl: unable to lock HW IRQ 1 for IRQ
[ 18.615897] genirq: Failed to request resources for lis3mdl-trigger (irq 135) on irqchip sunxi_pio_edge
[ 18.625630] iio iio:device0: failed to request trigger IRQ.
[ 18.640124] st-magn-i2c: probe of 1-001e failed with error -5
[ 18.820645] SPI driver st-magn-spi has no spi_device_id for st,lis3mdl-magn
[ 18.827708] SPI driver st-magn-spi has no spi_device_id for st,lsm303agr-magn
[ 18.834929] SPI driver st-magn-spi has no spi_device_id for st,lsm9ds1-magnSeems like the driver could not start. Does anyone have a similar issue?
//edit: Very interesting: If I boot the Pinephone with the Lora Backplane, the magnetometer shows up successfully. Maybe this thread should be moved to the Hardware-Topic