Solid Model/Accurate Blueprint

[w1ntermute0]

It would be nice to have the power an reset buttons as well. Other than that. Thanks for the work

Hah - I haven't soldered the one I got on yet - are those switches both the same momentary contact or are they different components?  If someone has measurements now I could add them to the cad model, otherwise I'll have to measure later after I put it on.

wm

[norm24]

About this model it should be. Here is a step-file
https://drive.google.com/open?id=0BwdGZc...WJRRkRzWW8

[knightridar]

Saw some mention of dimensions in the 'Cases and Enclosure Question' thread, but I'm hoping for a nominal dimension solid model if possible, or at least a good print to work from. I'm a machinist by trade and want to try a few enclosure designs and the one REV B drawing is only for outer board dimensions which isn't going to do it. I want to be able to design and machine aluminum cases with integrated standoffs and the like. 

Will a non-STL* model be available sometime soon? I would like to start designing before the board arrives in March.

*(hopefully something like a STEP or IGES solid model, or dare I say SolidWorks)

 try this:

https://grabcad.com/library/pine64-a64-db-2gb-rev-b-1

---

If it helps anyone I threw together a rough CAD model, it's located here (see photo in attachment):

http://www.3dcontentcentral.com/parts/do...alogid=171

This is all based on measurements I took off my board, so don't get mad if you use it and your holes don't line up or whatever, but I tried to be as accurate as possible.  Let me know if you see any corrections needed.

Enjoy.
wm

this is also available thanks

https://grabcad.com/library/pine64-a64-db-2gb-rev-b-1