07-03-2016, 03:31 AM
hello,
i recently bought a usb hub with a rj45[ethernet] port also. the port is recognized and set up as a 2nd ethernet at boot if two cables are connected or during a session if the cable is connect. throughput is fine.my issue is if the ethernet line 1 [the one on the board] is not connected while the 2nd line is operational the animation for searching for ip address for cable 1 is continuous. i'm thinking that either there should be no anjimation since no cable is physically attached or the search and the animation should time out after a cerain period of time, 30 - 90 secs, as desired. are there any settings i should do? thanks.
i recently bought a usb hub with a rj45[ethernet] port also. the port is recognized and set up as a 2nd ethernet at boot if two cables are connected or during a session if the cable is connect. throughput is fine.my issue is if the ethernet line 1 [the one on the board] is not connected while the 2nd line is operational the animation for searching for ip address for cable 1 is continuous. i'm thinking that either there should be no anjimation since no cable is physically attached or the search and the animation should time out after a cerain period of time, 30 - 90 secs, as desired. are there any settings i should do? thanks.