PINE64   ›   PINE A64(+)   ›   Pine A64 Hardware, Accessories and POT   ›   Pi2, Euler and Exp GPIO Ports   ›   Controlling a Servo Motor

Controlling a Servo Motor
casmiguefl
Pine Initiate
**
Joined: Aug 2016
Posts: 4

Reputation: 0
#1
07-13-2017, 01:14 PM
I'm finding it impossible to work with GPIO and wanted to connect a small servo motor to the Pine64 in order to control it.

In this particular case I want to set 2 particular degrees depending on a variable.
With an Arduino, this is basic: Servo.attach(#controlpin); Servo.write(#angle);

Any tutorials around on how to do it here?
  Reply


Messages In This Thread
Controlling a Servo Motor - by casmiguefl - 07-13-2017, 01:14 PM
RE: Controlling a Servo Motor - by Luke - 07-13-2017, 02:36 PM
RE: Controlling a Servo Motor - by pfeerick - 07-13-2017, 10:59 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
Information Howto: Controlling Pine64 GPIO via the filesystem (sysfs) on linux pfeerick 4 11,909 01-24-2019, 03:36 AM
Last Post: Fifth
  Active Cooling 5v brushless fan with Motor Speed Controller soft PWM MarkHaysHarris777 14 22,358 06-26-2017, 03:16 PM
Last Post: ishwest
  Active Cooling soft PWM follow-on fan motor speed controller driver MarkHaysHarris777 3 6,758 09-02-2016, 11:46 PM
Last Post: MarkHaysHarris777

Forum Jump:


Users browsing this thread: 1 Guest(s)