10-05-2023, 05:00 AM
My Pinephone keyboard stopped working and after doing some inspection, I discovered that the GND wire has been torn apart at the hinge - too close to the upper case to reconnect it with solder.
The only way I see to fix this is replacing the cable.
However, I'm having trouble finding information on how the top part is held together.
Is the upper part of the keyboard (where the phone goes) glued or held together mechanically?
Or is the 3D model for the case available someplace? I've looked for it in the wiki and searched for it without success.
The only way I see to fix this is replacing the cable.
However, I'm having trouble finding information on how the top part is held together.
Is the upper part of the keyboard (where the phone goes) glued or held together mechanically?
Or is the 3D model for the case available someplace? I've looked for it in the wiki and searched for it without success.